Head Unit

Discussion in 'Modifications And Maintenance' started by Trborex, Aug 13, 2006.

  1. Trborex
    Offline

    Trborex Well-Known Member

    Likes Received:
    1
    Trophy Points:
    103
    Im still using the Stck unit and was wonder if it is possible to run an amp and sub off this unit or if i need to go with an aftermarket unit. I understand that if it is possible that it wont be that big of an output..... Also how in the hell to u get the facing off from around the unit???
     
  2. AspitFire
    Offline

    AspitFire Well-Known Member

    Likes Received:
    193
    Trophy Points:
    248
    you can you need a line out converter they can be picked up at best buy for around 20 bucks or so
     
  3. readymix
    Offline

    readymix ...Lest ye be trod upon... Staff Member

    Likes Received:
    2,892
    Trophy Points:
    473
    The facing comes off this way:

    Open the cupholder.
    Remove the two phillips head screws
    Remove the cupholder
    Pull the vent assembly off.
    Disconnect the Hazard button
    Pry the facing panel off the stereo. It is held in by locking tabs so it just takes some carefully placed elbow grease. Don't pry too much, as it could snap and break.
    Voila! You're done.
     
  4. SenorSubie
    Offline

    SenorSubie Well-Known Member

    Likes Received:
    0
    Trophy Points:
    101
    You could also use the high imputs on your amplifier
     
  5. Imprezme02
    Offline

    Imprezme02 New Member

    Likes Received:
    0
    Trophy Points:
    0
    Would help alot if we knew what type of vehicle you are planning to do this on, for the facing...

    If its a 02+ I know all you need is a flat head, to get the trim off, and a phillips to get the mounting kit out. Takes literaly 1 minute.
     
  6. Trborex
    Offline

    Trborex Well-Known Member

    Likes Received:
    1
    Trophy Points:
    103
    Its an 05 WRX