ID wiring help..

Discussion in 'Modifications And Maintenance' started by Spencer, Dec 17, 2015.

  1. Spencer
    Offline

    Spencer Member

    Messages:
    17
    Likes Received:
    3
    Trophy Points:
    13
    Location:
    Minneapolis
    Fixing the car up and found some wiring that are unplugged on the car. Anyone know what they are and where they plug too?

    The one circle in red harness goes up into the ignition and the two black wire coming out from it gets grounded to the door.
    [​IMG]

    Red one is the same one on top and the blue one are two connectors coming from the inside left side harness. The one that is cover in electrical tape is jump between two wires on the harness.
    [​IMG]

    Same one as above, but closer. Comes right off of the large harness from the driver side.
    [​IMG]
     
    Last edited: Dec 18, 2015
  2. Terry Ammerman
    Offline

    Terry Ammerman Well-Known Member

    Messages:
    1,394
    Likes Received:
    457
    Trophy Points:
    268
    Gender:
    Male
    Location:
    Elk River, MN
    The green one is the test connector. Leave it unplugged. The white one, I'm not sure.
     
  3. Spencer
    Offline

    Spencer Member

    Messages:
    17
    Likes Received:
    3
    Trophy Points:
    13
    Location:
    Minneapolis
    Yep, I found that out by searching was just curious at the ones that are circle in red and blue (just fixed it so you will know). =)
     
  4. pillboy
    Offline

    pillboy Well-Known Member

    Messages:
    3,660
    Likes Received:
    3,767
    Trophy Points:
    348
    Gender:
    Male
    Location:
    Saint Cloud
    That first picture with the two black wires loose and not covered does not look like OEM harness...I don't think the factory leaves long runs of wire uncovered like that.