Subaru RODs: Forged??

Discussion in 'Modifications And Maintenance' started by FuJi K, Jan 7, 2008.

  1. FuJi K
    Offline

    FuJi K Well-Known Member

    Messages:
    3,850
    Likes Received:
    121
    Trophy Points:
    248
    Location:
    St. Paul, MN
    Posted this at NASIOC but wanted to share it here as well for those looking for rod questions. Hopefully this helps with selecting the right rod for your application. I will probably just purchase STi rods for my build because I'm not going with MAJOR power upgrades.

     
    FuJi K, Jan 7, 2008
    #1
  2. wagonL
    Offline

    wagonL Well-Known Member

    Messages:
    712
    Likes Received:
    1
    Trophy Points:
    203
    i think you should take my alternator to the shop....since you seem kinda bored.....




    hahah

    well...im goign with ej22t.....
     
    wagonL, Jan 7, 2008
    #2
  3. piddster
    Offline

    piddster Lone Wolf

    Messages:
    4,735
    Likes Received:
    15
    Trophy Points:
    123
    Gender:
    Male
    Location:
    Boostonia
    Eagles are cheap and work well. Why not if you're already in there? I'm sure you saw NICO's EJ22T pretty much explode on the BBS. He was running a decent sized snail and his practices are questionable though...
     
    piddster, Jan 7, 2008
    #3
  4. FuJi K
    Offline

    FuJi K Well-Known Member

    Messages:
    3,850
    Likes Received:
    121
    Trophy Points:
    248
    Location:
    St. Paul, MN
    ya, his EJ22T rods went. Hopefully mine'll hold until I get the other 22T built. The current shortblock I just put in new rod/main bearings.

    This EVO3-16G is pushing the limit though somewhat.... lolz
     
    FuJi K, Jan 7, 2008
    #4
  5. piddster
    Offline

    piddster Lone Wolf

    Messages:
    4,735
    Likes Received:
    15
    Trophy Points:
    123
    Gender:
    Male
    Location:
    Boostonia
    piddster, Jan 7, 2008
    #5