anyone knows how to change clutch on a ford probe?

Discussion in 'Off-Topic' started by wagonL, Aug 28, 2005.

Thread Status:
Not open for further replies.
  1. wagonL
    Offline

    wagonL Well-Known Member

    Likes Received:
    1
    Trophy Points:
    203
    well..my brother'n'law's ford probe is a V6..and manual..so he needs a new clutch...anyone knows how to? i know its basically same as honda..etc...for the front wheel drive..but haven't done axle for front wheel drive before..so...anyone?

    wagonL
     
    wagonL, Aug 28, 2005
    #1
  2. morganm
    Offline

    morganm New Member

    Likes Received:
    0
    Trophy Points:
    0
    Same as any other car. Either slide the tranny back enough, or pull the tranny, or pull the engine.
     
    morganm, Aug 29, 2005
    #2
  3. AspitFire
    Offline

    AspitFire Well-Known Member

    Likes Received:
    193
    Trophy Points:
    248
    good luck, man i had two ford probes in my day. The clutch job is not the easiest job for the average joe. The engine is traversly mounted and the tranny sits on the drivers side of the motor. Not much space to work in there. I would recommend you check out www.mnpoc.org and ask some of the guys on there they are super cool, and know quite abit of stuff.
     
    AspitFire, Aug 29, 2005
    #3
  4. wagonL
    Offline

    wagonL Well-Known Member

    Likes Received:
    1
    Trophy Points:
    203
    well...cool..thanks guys...
     
    wagonL, Aug 29, 2005
    #4
Thread Status:
Not open for further replies.