Factory Short Shifter 02-07 WRX

Discussion in 'For Sale : Car Parts' started by TheSnowman, Feb 14, 2013.

Thread Status:
Not open for further replies.
  1. TheSnowman
    Offline

    TheSnowman Well-Known Member

    Messages:
    1,440
    Likes Received:
    12
    Trophy Points:
    123
    Location:
    Twin Cities MN
    For sale is a Factory short shifter for a 02-07 WRX. not sure on other years and model fitments.

    I bought this as kind of a project. I cut about 1.5 inches out of the shifter and welded it back together to lower the height of the shift knob. I loved the new height of it however the shifter was to narrow for my linkage. Just trying to break even on this little project.

    ASKING $20

    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
     
    TheSnowman, Feb 14, 2013
    #1
  2. Mitchum
    Offline

    Mitchum Well-Known Member

    Messages:
    418
    Likes Received:
    88
    Trophy Points:
    213
    Gender:
    Male
    Location:
    South MPLS
    Interested, but with the modifications were there issues with the install or proper function?
     
    Mitchum, Feb 14, 2013
    #2
  3. TheSnowman
    Offline

    TheSnowman Well-Known Member

    Messages:
    1,440
    Likes Received:
    12
    Trophy Points:
    123
    Location:
    Twin Cities MN
    no it installed just fine and functioned properly. it didn't fit my linkage properly cause i had the factory linkage. from what ive researched this will only fit if the car came with a factory short shifter. the part that the bolt and bushing goes through is narrower on this one compared to a stock shifter.
     
    TheSnowman, Feb 14, 2013
    #3
  4. TheSnowman
    Offline

    TheSnowman Well-Known Member

    Messages:
    1,440
    Likes Received:
    12
    Trophy Points:
    123
    Location:
    Twin Cities MN
    $$OLD
     
    TheSnowman, Feb 17, 2013
    #4
Thread Status:
Not open for further replies.