Fog lights, cruise control don't work. Can anybody help me??

Discussion in 'General Subaru Discussion' started by cairowrx, Jan 5, 2006.

Thread Status:
Not open for further replies.
  1. cairowrx
    Offline

    cairowrx New Member

    Likes Received:
    0
    Trophy Points:
    0
    Hey guys my name is Amro. Some of you i've met. I used to have the 97 Nissan Maxima. Finally got rid of it and moved on up with a 02wrx. I have two issues tho. The first would be my fog lights dont work. I checked the fuse but it's fine. Second would be the the cruise. Did the same for the fuse it's also fine. Can anyone think of what can be the problem?

    Thanks :lol: :lol:
     
  2. WRX1
    Offline

    WRX1 _ Staff Member

    Likes Received:
    727
    Trophy Points:
    348
    did you check to make sure the switches are plugged in?? Since both switches are located in the same panel, and you need to disconnect the switches to remove that panel. I would check that out and go from there.

    Russ
     
  3. cairowrx
    Offline

    cairowrx New Member

    Likes Received:
    0
    Trophy Points:
    0
    They both light up when i turn both on. You think it can be a fried wire????
     
  4. Yang
    Offline

    Yang Well-Known Member

    Likes Received:
    3
    Trophy Points:
    223
    Possibly fuses otherwise check to make sure the harness are connected correctly to the switches
     
  5. driftin240
    Offline

    driftin240 Well-Known Member

    Likes Received:
    24
    Trophy Points:
    223
    your fog lamps could be burnt out, have you checked the connectors on the lamps? If the lights are working on the switches, the switches are getting power, but it doesn't mean the relays are.
     
  6. driftin240
    Offline

    driftin240 Well-Known Member

    Likes Received:
    24
    Trophy Points:
    223
    Do your High Beams work?
     
  7. WRX1
    Offline

    WRX1 _ Staff Member

    Likes Received:
    727
    Trophy Points:
    348
    Also, when you press in the fog switch with the ign on, you should hear the relay click. The fog relay in under the dash right next to the fuse box (I think it is the 3rd one up from the bottom). I would check that for the clicking, and if it does go farther downstream. I would then make sure that you highbeams on NOT on (Unless the fog relay has been modded) and make sure that the bulbs are ok (check the wires with a meter).

    Russ
     
  8. driftin240
    Offline

    driftin240 Well-Known Member

    Likes Received:
    24
    Trophy Points:
    223
    Russ is right, make sure your highbeams ARE NOT on or your fogs will not work. Your fog lamps are run through the high beam relay at one point though, so if your high beams work...you narrowed your search somewhat.
     
  9. driftin240
    Offline

    driftin240 Well-Known Member

    Likes Received:
    24
    Trophy Points:
    223
    Looking at the diagram, your cruise control is run through the horn relay...retarded huh, anyways, does your horn work?
     
  10. cairowrx
    Offline

    cairowrx New Member

    Likes Received:
    0
    Trophy Points:
    0
    Yes my high beams do work
     
  11. DISCOPOPE
    Offline

    DISCOPOPE Well-Known Member

    Likes Received:
    17
    Trophy Points:
    223
    check the relays..
     
  12. SubarWRX
    Offline

    SubarWRX New Member

    Likes Received:
    0
    Trophy Points:
    0
    Did you ever figure out whaty was wrong with your lights???

    I was coming home last night and now mine dont work.....fog lights dont work,High beams dont work, cruse control is working though. one of my parking lights is out too
     
  13. cairowrx
    Offline

    cairowrx New Member

    Likes Received:
    0
    Trophy Points:
    0
    Yeah the problem was that my bulbs were burnt out (Never bothered to check them). Got those replaced for $10 ( You'll find them at walmart much cheaper than any where else). But for my cruise i found out that it was disconnected. I still need somebody to help me connect it for me (i'm new to subaru's). Does anybody know where to locate the relays or what ever it is that needs to be connected?
     
Thread Status:
Not open for further replies.