FS: Rolling 01 RS/RSVX shell with lots of stuff

Discussion in 'For Sale : Car Parts' started by Colin, Oct 10, 2012.

Thread Status:
Not open for further replies.
  1. Colin
    Offline

    Colin Well-Known Member

    Likes Received:
    0
    Trophy Points:
    201
    Buy my broken dream!
    BEST OFFER above $1000
    WILL NOT PART OUT UNTIL NO ONE WILL BUY THE WHOLE THING

    THIS CAR IS IN FARGO. I CAN DELIVER IT ANYWHERE IN THE STATE OF MN or ND for the price of gas.

    FS: a salvage title 01 RS that has been retitled in MN. Had a professional straighten the little bit of frame, welded in a new A pillar skin.Has a 92 SVX motor in it. needs some work to run and drive.

    The car:
    SVX motor that ran before it was installed
    02 WRX trans with KAZZ straight cut 1-3, about five miles on it since a rebuild.
    02 WRX diff.
    Exedy stage 3 6 puck sprung clutch
    Aluminum hood
    V6. carbon replica wing from Bakemono imports on RS25.com
    OEM spats
    Stainless brake lines
    Rally armor mudflaps, literally never seen a drive.
    Whiteline 32mm rear sway bar
    Aluminum endlinds F & R with poly bushings
    Unistalled stainless BEAT rush trunk seal off plate
    WRX brakes and rotors
    SVX single stage brake booster and non-abs master cylinder

    DOES NOT RUN CURRENTLY

    The bad:
    You will need to figure out a wiring setup or talk to Chux if he even remembers what was going on with this.
    Only a dash and passengers seat inside.
    Front end stuff is beat up.
    Dirty
    Needs work

    The Extras:
    Brand new in box OEM fenders
    Brand new in box walboro 255 pump
    Brand new clutch master cylinder etc.
    new hard brakelines for the engine bay
    k-sport hydraulic e-brake
    wrx top mount
    04 STI ALUMINUM CONTROL ARMS (low mileage)
    04 sti timing belt

    Story: i bought and fixed a salvage RS. I decided to SVX swap it. I accumulated parts buying and selling subarus, now I don't even drive my EG20 swapped wagon, so i don't plan on finishing this. Don't want to store it any more either.
    Pictures:
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
     
  2. bubba_crx
    Offline

    bubba_crx Well-Known Member

    Likes Received:
    11
    Trophy Points:
    103
    bump for an awesome guy, sad to see you're selling it.
     
  3. BroCo
    Offline

    BroCo Moderator Staff Member

    Likes Received:
    1,024
    Trophy Points:
    348
    This has Tash written all over it!
     
  4. Grayguy
    Offline

    Grayguy Well-Known Member

    Likes Received:
    84
    Trophy Points:
    133
    Looks like an awesome deal, wish i was looking for a project! GLWS
     
  5. choukhang
    Offline

    choukhang Well-Known Member

    Likes Received:
    55
    Trophy Points:
    213
    sweet thing you got there....wish i have the money...
     
  6. choukhang
    Offline

    choukhang Well-Known Member

    Likes Received:
    55
    Trophy Points:
    213
    Oh and if the whole car doesnt sale. I called the rear spats, jdm tailight, and v6 spolier... Heres my number if u decided to part ou 612 250 2139. Thanks.
     
  7. Tash
    Offline

    Tash Well-Known Member

    Likes Received:
    775
    Trophy Points:
    198
    Lol how did I miss this post? Caughty attention now
     
  8. Tash
    Offline

    Tash Well-Known Member

    Likes Received:
    775
    Trophy Points:
    198
    Lol guess oct. 10th seemed like a lot longer back then yesterday :rolleyes: damn I need to get my days straight....might have to pick it up just for the custom 2 tone paint! Any normal pics not the effect ones??
     
  9. Colin
    Offline

    Colin Well-Known Member

    Likes Received:
    0
    Trophy Points:
    201
    one of my children ran off with my normal camera, so it was GoPro all the way. If it turns up, new pictures will follow.
     
  10. Chux
    Offline

    Chux Well-Known Member

    Likes Received:
    1,489
    Trophy Points:
    398
    Couple ancient pics I took of it. REALLY wish I had room for it!! Want to trade for an XT6?

    [​IMG]

    [​IMG]
     
  11. DoughtCom
    Offline

    DoughtCom Well-Known Member

    Likes Received:
    236
    Trophy Points:
    228
    Are effin' kidding me, what a deal. GLWS.
     
  12. Dynapar
    Offline

    Dynapar Well-Known Member

    Likes Received:
    31
    Trophy Points:
    358
    I am interested. Any idea what it would add $$ wise to deliver it to St. bonifacius (west side of the twin cities)
     
  13. Colin
    Offline

    Colin Well-Known Member

    Likes Received:
    0
    Trophy Points:
    201
    It's between 200-300 in gas to trailer it down to anywhere near the cities.
     
  14. Colin
    Offline

    Colin Well-Known Member

    Likes Received:
    0
    Trophy Points:
    201
    There are a lot of people after different things. A part out might be coming. Also: how do i edit the original post to answer the commonly asked questions?
     
  15. KA-T_240
    Offline

    KA-T_240 Well-Known Member

    Likes Received:
    223
    Trophy Points:
    248
    Colin, mods have to edit posts in the fs section.
     
  16. Leviathan
    Offline

    Leviathan Member

    Likes Received:
    13
    Trophy Points:
    28
    I'm interested in the car as well. I know Chux and could probably force him to look at it.
     
  17. Chux
    Offline

    Chux Well-Known Member

    Likes Received:
    1,489
    Trophy Points:
    398
    A coworker of mine is VERY interested in it. He just sold a vehicle and this is high on his list. I don't think I've got your number any more, pm me your contact info...
     
  18. paragonbiker
    Offline

    paragonbiker Member

    Likes Received:
    5
    Trophy Points:
    13
    If there is a part out dibs on transmission!
     
  19. Tash
    Offline

    Tash Well-Known Member

    Likes Received:
    775
    Trophy Points:
    198
    Really?? Dibs???
    Still waiting on some info and pics op......still interested in whole setup
     
  20. Colin
    Offline

    Colin Well-Known Member

    Likes Received:
    0
    Trophy Points:
    201
    Things i've been asked:

    Rust: there's some in a bondo spot on the roof maybe 3 square in ch spot. minimal rust

    Engine bay. Radiator support on top has been cut out to fit a custom radiator that comes with the car.

    Brakelines: there are none inside the car. only engine bay and stainless lines to calipers.

    Money: I've got a bid in at 1000$ even. I'd like more. Someone should offer me more.

    I'd rather see posts then PM's. because then everyone gets the answers instead of just one person.
     
  21. Hal
    Offline

    Hal Member

    Likes Received:
    3
    Trophy Points:
    18
    Genuine Morette head lights? This is a hell of a damn sweet deal. Im gonna HAVE TO talk my gf into getting this.
     
  22. Hal
    Offline

    Hal Member

    Likes Received:
    3
    Trophy Points:
    18
    Oh btw, I noticed post 1 photos are missing some parts from post 10. How is it currently sitting?
     
  23. Chux
    Offline

    Chux Well-Known Member

    Likes Received:
    1,489
    Trophy Points:
    398
    The 2 pics I posted are probably 4 years old....




    I would love to see my coworker pick it up and make it a driver again. But, for anyone else interested, here's what I remember of the setup.


    From the firewall forward and most of what's under the dash, it's essentially 100% SVX wiring. The RS harness plugs where spliced in on the passenger side at the base of the A-pillar for all the lights in the rear of the car, and the fuel pump. I'm also pretty sure the sunroof wiring was tapped in so it would work.

    Colin had planned to use the SVX projector headlights, so all wiring for that was left as-is, plugs for the corner markers and turn signals were (probably) spliced onto the SVX harness. I'm also pretty sure it has the SVX fuse boxes.

    Wiring to use a GC gauge cluster (don't remember if it was stock RS, or maybe a jdm unit...), was started, but I was not able to finish it, as I did not have the correct wiring diagrams when I was there (I had '01 FSMs.....but once I started working with them, I realized they were for a different market, and therefore for a GD).

    The ignition switch was not wired in, instead there was a panel with switches for Ignition, Acc, and a starter button. As I remember, when I was there, the fuel pump primed properly, but there was a problem with the starter, so I was not able to test-fire. But it should run as-is.

    It was also converted to manual windows, so no power windows to worry about. Also no power locks.



    Keep in mind, it's been about 4 years since I was there working on it, and I think it was a full year earlier when I started working on the harness. But it doesn't look like much has changed since then :(
     
  24. Tash
    Offline

    Tash Well-Known Member

    Likes Received:
    775
    Trophy Points:
    198
    Still waiting on pics of rust and bondo area
     
  25. Grayguy
    Offline

    Grayguy Well-Known Member

    Likes Received:
    84
    Trophy Points:
    133
    Chux buy it and park it at izzys!
     
  26. Chux
    Offline

    Chux Well-Known Member

    Likes Received:
    1,489
    Trophy Points:
    398
    YOU buy it, and park it at izzy's.....and I'll help you get it going. :p
     
  27. Grayguy
    Offline

    Grayguy Well-Known Member

    Likes Received:
    84
    Trophy Points:
    133
    ^ I was tempted, that adult could VS. should issue has been rearing it's ugly head a lot lately
     
  28. Colin
    Offline

    Colin Well-Known Member

    Likes Received:
    0
    Trophy Points:
    201
    pending sale tomorrow.
     
  29. Leviathan
    Offline

    Leviathan Member

    Likes Received:
    13
    Trophy Points:
    28
    Car is sold. I believe there are quite a few other parts available still. Thanks Colin.
     
  30. tangledupinblu
    Offline

    tangledupinblu Event Coordinator Staff Member

    Likes Received:
    8,956
    Trophy Points:
    573
    Well post a thread if there is anything that you don't need and are planning to get rid of. i
     
  31. tangledupinblu
    Offline

    tangledupinblu Event Coordinator Staff Member

    Likes Received:
    8,956
    Trophy Points:
    573
    I have an RSVX swap also...could always use spare parts for the race car!

    Congrats on the sale Colin!
     
  32. Colin
    Offline

    Colin Well-Known Member

    Likes Received:
    0
    Trophy Points:
    201
    car is sold. MODs, please close the thread. Thanks
     
  33. Ctracey218
    Offline

    Ctracey218 Playpen Wrangler Staff Member

    Likes Received:
    395
    Trophy Points:
    268
    Done!
     
Thread Status:
Not open for further replies.