Welp it finally got here today!!!! My V3 dp and G200 catback. I'll have picks up here pretty soon. Question though i'm getting the DP powdercoated but in the meantime the CB should mate right up to the stock DP right? And since it's all post cats i should have no CELs or anything.
Sounds right to me, I just have a cat back and it mated up to the stock dp, but if you are going to be doing the dp soon, I would suggest just waiting..
the gaskets is why I would of waited, but if you have exra go for it. I know the feeling, it took everything I had to wait 2 days to put my cat back on.. good luck and post up a sound clip and pics when it is done..
Welp it sounds pretty much stock right now, i'm assuming that is due to the stock DP but i will post up pics and audio of the whole shabang when she's done here in a week or two. But it went in pretty quick took me like 30 min total to get the old one out and the new one in. One thing is that the resonator is darn close to the universal joint in the middle of the drive shaft. Anyone else notice this?
well you havent got a lot of room to work with when its 2.5 in piping yet alone 3in piping.. either that or it scrapes on teh ground.. lesser of 2 ecils for clearance
So i'm an idiot, i didn't take the baffle outta the tip in my excitement to get out and drive it last night. I came out to the car this morning and i looked at the tailpipe and went....@#$%!@#$%!@#$%!@#$%!....hahahaha sounds SOOOOOO much better now that i took that POS outta there.
