where did you get tuned?

hey guys, well did some looking around and couldn't find a place anywhere where people said they got tuned, and wish they would have gone to gotten tuned. good stories bad stories ect....

I'll be doing the DB20g build up (yes, with a santa bag full of supporting mods) just worried about driving to PDX tuning in Portland OR (1,600 miles away) or Axis power (940miles) on hopes and dreams or some guy that knew enough about tuning and did a street tune to drive it there....
do I have any options? I would like to refrain from driving it as much as possable with no tune

any feed back would be appreciated, thanks guys!

Nick

 

I saw that. thanks. it's just that, that will be too early for the build up. it'll be about the end of May when I get all the parts/ordering finished up
otherwise that would be THE way to go and just have him street tune it so I can drive to ---- to get the other tunes

 

You can always try P&L in Chicago...

 

I don't think driving it 400 miles on no tune is any better than driving it 900 miles, Dreamis.

What are you using for engine brains?

 

I got my car tuned on the southbound portion of 494 just after the entrance ramp from hwy 7.

 

i tune with my logic module, i put parts on and it learns them, lol

 

Jorge will typically send you a base map to get you there, kind of like he did for KSAL and Disco when they went down there a few months ago. Or like he did for me when I had to break in my 20g setup or when I had to break in my GT35R setup. Those are the brains im using, s0n.

 

<== 280 between University Ave and Lexington!

 

thanks Dream, might have to try that route.

Wall and Wage.. I heard the northbound 494 was better..? cooler air...being from the north
lol pretty funny

 

Hell, with Enginuity you could drive 100 miles on the backroads of MN and tune it yourself. Of course, you won't have the dyno numbers to show the rest of us, but you can slap it on the dyno at any time.

 

<== 36 westbound between 61 and 35E