So what you're saying is someone used a 1996 Legacy GT-B Rev B Twin Turbo as a rural mail route daily driver? What the actual fu<k is wrong with people?
OK! let me see if I can put some focus into this for an update. Alright, $4000 bucks and a trip south of Ames IA we grabbed this Legacy, Good color, good deal! Girlfriend loves it!, drove ok besides a shudder from the rear end somewhere, no big deal. Hopped on the road for home, after about 2 hours it started to hiccup really bad, so we had to leave it at a gas station and come back the next day with the trailer. Loaded her up, dragged her home, car ran fine at times but after getting all warmed up it would start to have some problems, but was fine when cold, later problem.... 200 dollar facebook marketplace Pedders 04 STI suspension and lowering springs, literally brand new absolute score. Got it sitting perfect. Around this time i figured out the issue with the shudder from the rear end, The rear spider gears were completely locked up, so that fixed that issue, still would have some hiccups when warm, I figured it was the clunky 4eat that the car had. Other issue this car had was it was never clean on the inside, and we found out that Iowa dirt road dirt is no joke. We went to a good buddies house and completely blew this car apart to clean it, ruined his driveway, all our lungs, ETC.
We had the dash out, we had the headliner out, every single thing was out of that interior to clean this dirt out. its everywhere and im still finding it after all this work. We also cleaned up a ton of that extra Japanese wiring that didnt work any more, replaced all the blown speakers, ETC Got it all back together, moved to rental house with a garage so I could get back to my old self. Last winter I hatched a plan to put a 6 speed in it, because that 4eat was ( in my mind) the issue with the car hiccuping. So we starting to rip it apart again. ( we added all the zero sports dress up stuff I could find) ( you can still see that engine bay is full of dusty dirt) Got a nice used Snap-On tool box from the Matco guy, he dropped it off at my house and I actually just paid it off today. WooooHoooo. Garage decorations are from the Chilson Subaru dealership before they sold to Morries. Absolute score and worth the drive to Eau Claire.
Heres my Copart score donor car, 06 WRX TR with an 07 JDM STI Spec C transmission, coupled with an ACT clutch and regular 02-05 wrx r160.... Not rich enough for an r180 yet. Upon researching wiring for these JDM automatic legacys, they use a completely different ECU/TCU setup than we are used to here in the states, So my original plan was to make a jumper harness out of this extendo harness thingy i found on Buyee, and just pin the wires to the different plugs for the manual ECU for these cars, The manual ECU shares the same plugs with like DSMs and Miatas, 1st gen Legacys, etc. Someone on the 2nd gen legacy facebook group got into an accident with his Manual 1996 Legacy GTB, he sold me the whole bulkhead harness, SCORE!! So i scrapped my wiring project that probably would have sucked to do and skipped straight to good old fashioned "parts hanging" This time i took all the harness out and HVAC stuff out and cleaned that way way more, you can see its STILL dirty in there. I got the manual gauge cluster from the crashed car and swapped the speedometer over for the mileage to match. I wanted the manual cluster because these 2nd gen JDM cars have the PRNDL in the cluster unlike USDM. And last time we had the cluster out and apart to clean all the dirt out of it, the fuel gauge needle broke, no problem though. And BOOM! Good as new! (The JDM Manual cars also have an 8250 redline!) With doing this swap with the manual ECU, it effectively is the same as a v3-4 STI. It Uses 550cc injectors, and a larger maf sensor, so all that got swapped too.
I never wanna do this again due to all of the vac lines that are all rock solid from age, there are so many, Broke a few, Both BPVs broke on removal, few other things, found some replacements, all good. Pictured here is the black box of death, I will insert a diagram for those unfamiliar, dont touch it, leave it alone. The brains for the twin turbo setup/ turbo crossover. Alright alright, getting there Zero Sports BG5 muffler? Dont mind if I do! Got it all buttoned up in time for the Subarus and Cold Brews event at my work, Girlfriend took home a trophy for best Legacy! We changed the tires to a Yoko Advan in 225. instead of the 215s it came with, got the wheels all cleaned up and redone too. Its a nice car for sure, but still isnt happy when hot. Im suspecting a fuel pump, but I have not put that in yet.
We are probably gonna convert the 96 legacy to single turbo (because the car will be WAY faster) and part out my black 98 legacy. Turned 30 this year and realized you can only drive one car at a time, And being a Sr. Master tech at the dealership hurts your back and knees so much that its hard to work on stuff at home, where did that energy go??
I gotta do some photo rearranging and movement to get this story all up to date. Context, that Subarus and Cold Brews show at Walser Subaru in SSP (my work if anyone needs anything) was late August 2026, So we are almost there.
Dude, just wait til 40... Haha. Also, all that work for "girlfriend"? That thing is frickin sweet looking.
Alright, so back to the issue at hand, I Bought tickets to Subifest Midwest, got accepted into the show. But my car didnt run. Towed it from my parents to my house and dug into it. Issue was it would run on an apexi ecu, but not the chipped stock one which it needs. long story short, 1992 cam and crank wiring just died somewhere while the car was hibernating. replaced, good to go, kinda, it still has a super long crank and will kick the starter back sometimes, suspect ground problem somewhere but goodness me I have tried. I swapped sensors with the WRX, swapped ecus everything. (both have the same engine setup and tune) We thought that dip in the first 3 waves of the cam was a bad cam gear, so we swapped it, but it ended up just being the wires on the car side. Re wired everything, got it going again, sitting for so long definitely did not do this car any favors, it was so nice when I first got it! Ive had these Advan RC1 17s for a while now saving them for this car, not sure how I feel about them now. I think the car needs a wing to fit them better. Ive stashed side skirts for this too, finally put them on, mounted the boost gauge, got it looking passable and hit the road for Subifest. (got the car running 2 days before leaving) Forgot to mention, I got it running, then immediately the steering rack popped from an outer rack seal from being old and sitting for too long. So I drove to Subiefest with manual steering. Now manual steering is one thing, but external wastegate is needed. slapped one on with a MBC at 18 lbs. running good. (it was laying around)
Before I got to this, getting ready for subifest, I had a little side quest, Got a facebook message out of the blue from one of the coolest guys I have ever met. "Hey, you are into legacys, wanna come take mine away?" SURE! towed it straight to my house. He is a member on here, I forget the username. So there I was, looking at one of the coolest OG swaps I have ever seen. 06 STI engine, 06 WRX trans, total sleeper. I love it. This is the stuff that actually gets me going. Piece of history right here. Said needs radiator and had no brakes. I slapped some brake lines in, bled all the calipers I could. Went to the gas station, and did a pull or two. Absolutely needs a revive. Maybe my winter project. but goodness me is this the coolest car ever. Anyone need wheels? Parked it at my parents until I can get some time to dig back into it, new shell? (if I can find one)
Back to the topic at hand, I wrapped up my garbage enough to make it issue free (with my car) to Joliet and back. We tried hard and were first at the gate LOL Decent MPG too
I had the only 1g legacy there, honestly the show was kinda disappointing, not because of what it was, but i figured it would be huge, but for an event that is open from 10-4 not bad. Saw some cool stuff, some rare parts. I talked to tons of people so I didnt take too many pictures. Some cool prodrive parts on this one^
You ever seen an S202? neither had I 80% of the cars were new and boring. I got pics of the good stuff. Anyway, Girlfriend took home 2nd place best Legacy 89-99. She got beat by a JDM 2g sedan, IMO she should have got the win, The dude that hosted the event told her that he fought for her for the win. We will get em next time. She did get picked (by a staff member) for a ride-along with Scott Speed. Which is super cool.
Alright so, We had no trouble on the way down. On the way back her car started acting up around Wi Dells, suspecting fuel issue, checked vac lines, and actually replaced the FPR because we had one with us. hopped back on the road for about an hour, started acting up again. After it started acting up the 2nd time, we were 99.9 miles away, and my buddies AAA would tow it under 100 miles. so we had some food and waited for an update for that. Decided to get closer because they got no response, hopped back on the road for a while and it was good until a little outside of Hudson. I put a vise grip on the fuel return line and we got after it again, made it home. Took a nap and ordered that fuel pump.
Fuel pump arrived. pull the cover off AND! Thanks for reading and looking at these huge pictures these new phones produce. This is where I am at today... well 3 days ago. but Im tired. (forgot until I pulled this cover off that the JDM legacy did not have a fuel cap when we bought it, Im willing to bet this fuel pump is absolutely cooked, sock plugged, all of it)
And if we go way back in time, I had another thread with a 91 legacy ss. I parted that car out to a bare shell for my other projects a few years back. Friend of mine bought the shell and got it running again, cleaned all up. Thats a wrap. Ill be back in another 3-5 business years.
Iowa gravel roads are no joke. I grew up on them and it is typically impossible to see or breathe any time you follow someone. that wagon, on that suspension, with those wheels=money
Those wheels are an oem option! Never seen them in 17inch. The prefacelift cars got 16 inch. Heaps of those available, never seen another set of the 17s. Super cool
Another thing to mention for winter projects. I do have a link g4x, radium topfeed conversion rails, 1050cc injectors as well as a rotated gt28 for that silver wagon. I know literally nothing about link, who tunes them and do I need to add any other sensors for it. If anyone knows anything, I'd be happy to listen.
I wired a couple cars on Link ECUs back in the day, but never did any tuning. I recall a bit of a project to adapt a 2-wire IAC valve to an EJ manifold for one of them. But that was an old ECU at the time, the G4X is much better, so it should be able to control the stock valve. Should be standard standalone ECU stuff. Calibrate for stock sensors. As long as you can find data on the stock injectors and coils. Probably need a wideband controller.