I have a wrb 1999 2.5rs coupe, mostly complete, 99k miles. 5 speed. bent valves full interior. drivers door is good, passenger isnt. the silver is a 2000, not too much left from it Let me know what you need.
Really just need the light itself but if you'd rather sell the while spoiler that would be ok too. Any idea what you would like for them?
Also, what would you be asking for the rear seat brace that goes in between the trunk and the rear seat back? Previous owner tried to swap in a folding seat and we're trying to get it back to factory. Not 100% sure what all were missing.
Appreciate it man! Gonna need both the socket and the connector with a bit of wire left to splice into the cut harness from the PO.
Do you have a right rear knuckle with a good wheel bearing in it? I will also need the lateral link attached and if it's easier, lateral rod as well. (I think those are the correct names - The 2 bars connecting the knuckle to the body in front and behind the axle, parallel to the axle) Also, do you have a passenger side interior door handle? I just need the plastic bit where the large screw goes into, the piece is shown cracked in picture below
Is the interior still available? F/R Door cards, back seat, carpet, center console, head liner, A/B/C pillar trims, shifter area parts? Dont need the dash or radio/HVAC stuff.
I have front door cards with aftermarket leather instead of the checker pattern, stock checker rears, checker rear seat, I have a headliner that needs a clean, I have the abc pillar bits, unsure on center console.
