2005+ Subaru Legacy DRL removal.

Discussion in 'General Subaru Discussion' started by TabulaRasa, Jul 23, 2004.

Thread Status:
Not open for further replies.
  1. TabulaRasa
    Offline

    TabulaRasa Well-Known Member

    Likes Received:
    4
    Trophy Points:
    193
    The DRLs have been removed. I used to think I looked like a spazz driving around in this car because the headlights were on all the time, except when I pulled the handbrake. WTF?

    This job took me about 40 mins to do. This was mostly because I couldn't get enough leverage on the plug that needed pulling without having to disconnect the OBD connector from the lower dash cover and take the whole **** thing off. I could probably do it in 15 mins now though. :D

    Remove lower dash plastic cover:
    [​IMG]

    Identify modular white plastic DRL wire harness plug. The long cylinder to the right with the barcode sticker is for the steering collumn.
    [​IMG]

    Yoink!
    [​IMG]

    Mark plug with twist tie for future reference.
    [​IMG]

    Time to close it back up. Make sure none of the wiring harnesses are bent or rubbing hard edges.
    [​IMG]
     
  2. jprice
    Offline

    jprice Well-Known Member

    Likes Received:
    7
    Trophy Points:
    203
    Nice work!!

    Want to do it to Kelly's impreza wagon! I still have your flashlight! :-o

    -Jordan
     
  3. yosmiley
    Offline

    yosmiley Subie OG Missin'In Action

    Likes Received:
    6
    Trophy Points:
    223
    Tom, nice write up... so you went with an 05 Legacy or whose Legacy is that?
     
Thread Status:
Not open for further replies.