Install Q's

Discussion in 'Modifications And Maintenance' started by Quietkid, Aug 3, 2008.

  1. Quietkid
    Offline

    Quietkid Well-Known Member

    Likes Received:
    0
    Trophy Points:
    101
    I was wondering if anyone has a write up for an aftermarket boost gauge with an electronic display. And a write up for installing an aftermarket BCS from prodrive.Both for '04 wrx.
    Thanks.
     
    Quietkid, Aug 3, 2008
    #1
  2. readymix
    Offline

    readymix ...Lest ye be trod upon... Staff Member

    Likes Received:
    2,892
    Trophy Points:
    473
    For the gauge:

    Put a T connector off the vaccum line attached to the top of your BPV. Connect the electronic sensor to the T and connect a new hose to the BPV.
    Run the sensor wire into your car's interior space.
    Then follow instructions for the wiring as per the gauge instructions.
     
    readymix, Aug 3, 2008
    #2
  3. Bullwinkle
    Offline

    Bullwinkle Well-Known Member

    Likes Received:
    23
    Trophy Points:
    223
    As long as you can figure out which port on the Prodrive BCS goes where, the install should be almost the same as the GMBCS install. Shibbs did a good write up here.
     
    Bullwinkle, Aug 3, 2008
    #3
  4. Quietkid
    Offline

    Quietkid Well-Known Member

    Likes Received:
    0
    Trophy Points:
    101
    do u know where the stock guage wires come from in the interior ('04 wrx)? thanks.
     
    Quietkid, Aug 3, 2008
    #4
  5. Paul Revere
    Offline

    Paul Revere BANNED

    Likes Received:
    1
    Trophy Points:
    0
    Its on a harness maybe a foot and a half long, sadly I have no idea where it goes though.
     
    Paul Revere, Aug 3, 2008
    #5
  6. readymix
    Offline

    readymix ...Lest ye be trod upon... Staff Member

    Likes Received:
    2,892
    Trophy Points:
    473
    Not off the top of my head. Check Scoobymods.
     
    readymix, Aug 3, 2008
    #6