Minnetonka Subaru- 10% Labor and 20% Parts Discount

Kent^^ you got a pm

 

Brian,
I need prices on these parts please. All for the EJ257.

Head Gaskets
Cam Seals - qty 4
Cam Sprocket Bolt/ Intake Side - qty 2
TGV to Head Gasket (should be 2 gaskets)

Thanks!

 

Eric, You got a pm^^

 

Hope you can help on this....00-01 RS rear defrost button swtich little bulb went out, can I replace just the bulb or do I have to replace the whole unit?

thx

 

I have seen people replace the bulb only, i'll have to check the part# for you to find out if its available.

 

John: I looked at the picture and it doesnt appear to be replaceable, from what the picture says anyways... I think they can be taken apart (carefully) and the bulb could be replaced, maybe even with a new colored led or something.

 

Keyless entry remote for an '01 legacy

 

pm AWDimprezaL, he can give ya the hook up!

 

i need all the gaskets between the header/up -pipe connection and the DownPipe/catalytic converter.
and i need to know if you have them in stock.

 

BUMP!
Because i'm going to need those gaskets at the end of the week!

 

Never mind... i just stopped in and picked them up.

 

this is replaceable. i tried getting this part form the dealer and it was $10 for the tiny little bulb. i went to autolumination.com or something like that and bought a new one for like $2.

 

13054AA033

Do you guys have this part in stock? If so I'll just come by and get it.

 

How much for a in cabin air filter?

 

Looking for a few items...wondering if you could get some prices together for me?

2005 Legacy GT:
Spec B Steering wheel
All weather floor mats
Center armrest extention

Thanks very much

 

give me a qoute on an alignment. and what would it be to get an custom alignment.

 

Need front break pads....should I buy from Sub shop or any auto parts store?


I will come get them asap if I can get a discount.

Thanks,

 

engine gasket set for XT6...theoretically full set's exist

otherwise we'll need at least:
valve cover gaskets
oil pan
oil pump
front and rear mains
cam seals
water pump gaskets

maybe intake and head gaskets too (depending on the condition of the motor...we haven't gotten it yet

 

what would a set of Phase 1 Ej22E pistons cost?

 

nevermind, had to make an emergency stop up there this afternoon....and got what I needed

 

Martin,

I would need the engine serial number to get the exact piston for ya, but it looks like each piston would be 59.41. They come with rings, and the wrist pin.

 

^ not too bad. i wil lkeep that in mind. thx

 

If anyone is still interested in the BBS RK wheels we have some around still. 4 sets, and 2 more sets with 225/45 Falken Zeix512's on them.

$125.00 per wheel, or $532.50 for a set w/tax.

The Tire/Wheel combo's I could probably set up a deal for about $900

 

Hey Driftin, Can you try and find how much a 03 Manual shift surround and boot would be? I am just looking for the piece that goes around the shifter aswell as the boot. I am lookin to try and hide my 4EAT a little bit more and since finding a used one is going to be impossible I might as well go new. Once again, just the piece surrounding the shifter and boot or even just the boot. Thanks

 

^^bump^^ Just seing if you can find this part and how much it would cost.

 

The M/T Boot mount plate is $24.26

M/T Shift Boot is $48.54

M/T WRX Front Console Section (opening for a M/T Boot) $15.26

All special order parts, and those prices don't include tax.

 

Have any with teh 5x114 spacing?

 

how much for a set of front wheel bearings, and all the little bits go go with them, including a new castle nut?

 

STi pedal set?

 

As of yet....No Sorry!

 

$164.01 FOR BOTH SIDES w/tax. You don't need new axle nuts, and shouldn't need castle nuts cause they go on the ball joints.

So the parts needed would be 2 inner seals, 2 outer seals, and a 2 wheel bearings.

 

$119.24 Will have to order

 

Can I get a price on 05 WRX front rotors and pads. Thank you!

 

Front Pads and Rotors for an '05 WRX = $229.91 w/tax

 

How much would it cost to have an STI motor assembled for me? I supply most of the parts and pay for what I don't have, mainly bolts...

 

What do you mean by assembled. What's apart? The whole block, is it in halves, are the crank/rods together? What are we assembling?

 

how much would gaskets for an up pipe be?

 

Both the gaskets are in stock and $23.64 for both w/tax

 

ok thanks. i will stop buy sometime next week.

 

driftin 240 do your guys sell 06 sti fog lights... and also does morris subaru take off decals or would you send it in to another place to get stuff taken off thanks

 

ya but i like the look of them with fog lights on the car

 

There's a kit to install them. You would also need the Bezels which are color matched. Although I believe you bought are 06 White one....

The kit with the bezels would be $302.46 w/tax. Install is obviosly extra, but i'm sure you could do it yourself. Not very hard.

 

do you guys have them in stock and yes i do have a white 06 STi