WTB: Pistons & Rods for a EJ257

^ Give these guys a shout. They sell bearings ready to go.

http://www.calicocoatings.com/

 

Sleeve it for more boost baby!!

 

Wiesco or Mahle Pistons?

Or Other?

 

did you get this block from bob at morries bp?

 

why does it matter so much to everyone where he got the block??? just wondering!

 

Bryan, did you figure out which direction your taking for the block build...like pistons and other internals?

I'm going to start building a 2.5 block over the next few months and would like your discoveries/input, etc...

btw- who is building your block? pm me if needed.

thx!!!!


EDIT- My goal is 350-375 whp with WRX heads. Probably 20g with meth. stock turbo location since that's the cheapest for now

 

Any plans for the tranny Dave?

 

heck NO. I'm going to wait until my motor is broken in...then do 1 launch from 6K and listen for the explosion. :biggrin:

Okay...Yes. Either 07 sti or ppg. I'll shop around and pick up the best deal at the time.

 

Sounds fun, make sure you get that on video :biggrin:

 

I'm going with:
new stock crank
new stock rods
ACL bearings
malhe pistons or wiesco. Forged pistons either way
Leaving my stock heads on But with chimera larger ports
p&p gasket match intake mani
p&p throttle body
650cc (or larger) injectors
lightweight flywheel
other stuff when i think of it...

Hoping for 300+whp @ 20psi